Ethernet Extenders eliminate the need for rewiring, installing new switches, or being forced to run expensive fiber. Ethernet Extenders send a 10/100 Ethernet signal to extreme distances using existing wiring.

Versa Technology's Ethernet Extenders extend high speed data between networks that exceed the IEEE 802.3 standard off 100M or 330'.

Power over Ethernet (POE) Injectors allow both electrical power and data to be transmitted using standard Ethernet cabling with no reduction in data throughput. Using Power over Ethernet injectors eliminates the need to place a network device near a power outlet.

PoE Injectors are most commonly used for VoiP (voice over Internet Protocol), digital security cameras, wireless AP's or any device that is PoE compliant.

Power over Ethernet Splitters allow data and electrical power to be split to a device at the terminating end of a PoE injected cable run. PoE Splitters are used to allow legacy network devices to be powered remotely despite not being PoE compliant.

Power over Ethernet Splitters are most commonly used in VoIP solutions and legacy IP cameras.

Power over Ethernet Switches transmit electrical power and data to remote devices over standard twisted-pair wire in an Ethernet network. PoE Switches do not require modification to the existing Ethernet cabling infrastructure. The Power over Ethernet is standardized in IEEE 802.3af. This technology is useful for powering IP telephones, wireless access points, IP Cameras, hubs, and other PoE compliant appliance where it is inconvenient or infeasible to supply power at the device.

A Power Over Ethernet Hub is an aggregated or multiport injector of Power over Ethernet. The PoE hub follows the same principals of standard inline PoE technique; however the hub facilitates several entry points for PoE devices instead of only one port.
PoE Hubs are often installed in a network of existing non-PoE compliant switches. PoE hubs give an installer the ability to run power to multiple devices while using only one power outlet.

Indoor wireless AP's or bridges connect wireless devices to networks, providing network access for indoor environments. Installers increase employee productivity, enhance collaboration, and improve responsiveness between employees, partners, and customers wireless access points.

Wireless N Access Points offer comprehensive wireless coverage with up to nine times the throughput of 802.11a/b/g networks. Versa Technology carries both Indoor and Outdoor Wireless N Devices.

Outdoor wireless access points or bridges connect wireless devices to networks, providing network access for outdoor environments. Wireless N Access Points offer comprehensive wireless coverage with up to nine times the throughput of 802.11a/b/g networks. Outdoor wireless access points can also be used to bridge two location's or building's networks.

VDSL2 (Very High-bit-rate Digital Subscriber Line 2) extends DSL to extreme distances uses existing copper wiring (Category 3 or 5/6). DSLAMS are often used at Multidwelling (MDU/MTU) properties such as hotels, campuses, or condominiums. Versa Technology VDSL2 is the best choice for service providers looking to supply the Triple Play solution of HDTV, voice, and data without the cost of pulling new cabling.

ADSL2 (Asymmetrical Digital Subscriber Line 2) extends DSL to extreme distances uses existing copper wiring (Category 3 or 5/6). DSLAMS are often used at Multidwelling (MDU/MTU) properties such as hotels, campuses, or condominiums. Versa Technology VDSL2 is the best choice for service providers looking to supply the Triple Play solution of HDTV, voice, and data without the cost of pulling new cabling.

ADSL2+ and VDSL2 wired and wireless modems or CPEs (Customer Premise Equipment) serve as the end point or receivers for DSLAM networking devices. Modems provide service authentication, guaranteeing the security, QoS, and allocating of IP addresses. These modems are suitable for household Internet access, MDU/MTU installations, or small/medium sized business enterprises.